Swift Dry removes the water, dries your home or business and stops mold before it starts.
Sample carpet reading. Every job is measured the same way, from first visit to final check.
If water got into your home or business, we get it out, dry what’s left and deal with any mold that follows.
Burst pipes, overflowing appliances, storm leaks and sewage-free flooding. We extract standing water, then dry what’s underneath the surface, where problems start.
We lift, extract and dry carpet and pad in place whenever it can be saved, so you avoid a full replacement.
Mold can start within 24 to 48 hours of a leak. We dry fast and treat damp areas to stop it before it begins.
If mold has already taken hold, we contain the area, remove affected materials and clean surrounding surfaces so it doesn’t spread.
Offices, shops and rental units dried with minimal downtime, with work scheduled around your hours.
We answer, ask a few questions and send a crew. Most calls are booked in minutes.
Moisture meters and thermal cameras show how far the water spread, including behind walls.
Water is extracted, then air movers and dehumidifiers run until readings reach normal.
We check every area again and give you the final readings in writing.
Swift Dry serves homes and businesses in these Northwest Indiana counties:
A few minutes of action before the crew arrives can limit the damage. Only do these if it’s safe.
Most jobs take three to five days, depending on how much water there was, what it soaked into and the weather. We tell you what to expect after the first measurements.
Often, yes, especially when clean water was involved and we reach it within a day or two. If carpet or pad can’t be saved, we tell you before removing anything.
Many policies cover sudden water damage, such as a burst pipe. We document everything with photos and daily readings and can work directly with your adjuster. Coverage depends on your policy.
Yes. Swift Dry takes emergency calls around the clock and serves Northwest Indiana. Call (219) 713-9252 and we will tell you how soon a crew can reach you.
If it is safe, shut off the water source and turn off power to the area at the breaker panel. Stay out of standing water near outlets or cords, move belongings to higher ground, take photos for your insurer, and call us right away. Avoid using a household vacuum on water.
The cost depends on how large the affected area is, what kind of water it was, which materials got wet and how many days of drying equipment are needed. We give a free estimate before any work begins, so you know what to expect.
Common signs include a musty smell, peeling or bubbling paint, stained ceilings, warped or spongy floors and carpet that stays damp. We use moisture meters and thermal cameras to find water you cannot see.
A small spill on the surface, yes. But water usually soaks into the pad and subfloor, where household fans and towels can’t reach it. If the wet area is large or has been wet for more than a day, professional drying lowers the risk of mold and odors.
Mold can begin to grow within 24 to 48 hours in damp materials. That is why fast extraction and thorough drying matter, even when the water looks like it has gone.
Yes. If mold has already started to grow, we contain the affected area, remove materials that can’t be saved and clean surrounding surfaces. We also dry the space completely so the moisture that fed the mold is gone.
Yes. We dry offices, shops and rental units, and we schedule work around your business hours to keep downtime low.
Air movers and dehumidifiers make noticeable noise, similar to a box fan. We position them to be as unobtrusive as the job allows.
Contaminated water needs different safety steps and often full removal of porous materials. Call us and we’ll explain what’s possible for your situation.
Call any time for emergency drying anywhere in Northwest Indiana. For non-urgent jobs, email us and we’ll reply with a free estimate within one business day.
(219) 713-9252